Proper Dispensing Method for the 30 gram manual mix syringe

The 30 gram manual mix dispenser is easy to use. Please use the following techniques for optimal performance.

1. Find cap mounted between the syringe plungers. Break it off and have it ready to use to seal the syringe once done.
2. Using a knife, cut off the syringe approximately 1/4" from the tip, exposing 3/16" dispensing tunnels. If you cut the tip off too close to the end, you will have only 1/16" dispensing holes and the glue will not dispense properly.
3. Prepare a surface to dispense the glue onto for mixing. This could be a plactic cup, or cardboard or wood surface etc. Depress the plunger, squeezing out twin lines of hardener and resin. Be sure that you have approximately equal amounts of hardener and resin. At times one or the other may dispense out of proportion if the amount is very small. Do not dispense and mix more than 1/2 of the tube at once.
4. Mix the two parts for 1-2 minutes. The glue will appear mixed after a few seconds of mixing, but will not be mixed!
5. Apply the glue to your project.
6. Replace the cap, noting that there is a square and round shape to the inside of the cap. These must be properly aligned to fit onto the syringe. The side of the cap with the small rods is designed to go onto the syringe. The cap should slide on approximately 1/4" when properly fitted.
7. Store in a cool location, the glue will be useful longer if stored at cool or cold temperatures.